Jensen Portable Radio JWM 120 User Manual

batteries. Old or leaking batteries can cause damage to the unit and will void  
the warranty.  
7. Do not dispose of batteries in fire, batteries may explode or leak.  
1. Turn on the unit by rotating the ON/OFF Volume Control clockwise until a  
“click” is heard.  
2. Set the AM/FM Band Select Switch to “AM” or “FM” for the desired radio band.  
3. Turn the TUNING Control to select the desired radio station.  
4. Adjust the ON/OFF Volume Control to obtain the desired sound level.  
5. Turn off the unit by rotating the ON/OFF Volume Control fully  
counterclockwise until a “click” is heard.  
1. Rotating Hook Handle  
2. TUNING Control  
3. VOLUME Control (Power On/Off)  
4. Speaker  
1. To insure maximum FM tuner sensitivity, try rotating the unit to obtain the best  
possible reception.  
2. When tuning in AM reception, be sure to place the unit in a vertical position.  
To insure best AM sensitivity, try repositioning the unit until the best reception  
is obtained.  
5. AM/FM Band Select Switch  
6. Battery Compartment Door  
1. Clean the unit with a damp (never wet) cloth. Solvents or detergents should  
never be used.  
2. Avoid leaving the unit in direct sunlight or in hot or dusty places.  
3. Keep the unit away from heating appliances and sources of electrical noise  
such as fluorescent lamps or motors.  
4. This unit has rubber seals to minimize the risk of moisture getting inside.  
However, do not immerse it in water since permanent damage to the electrical  
and mechanical parts will result.  
This unit has been constructed to resist mild steam and light splashes  
from the shower or bath only. It should never be operated under running  
water and under no circumstances should it ever be fully immersed in  
5. Always wipe the outside of the cabinet thoroughly if it becomes wet with  
moisture or water splashes. This will help to prevent the internal parts of the  
unit from entry of water and possible moisture damage.  
This Shower Radio operates on 4 × ’AAA’ size (UM-4) batteries (not included).  
1. Open the Battery Compartment (located on the rear of the unit) by rotating the  
screws counterclockwise and lift off the Cover.  
2. Following the polarity diagram (+ and -) as shown inside the battery  
compartment, insert 4 × ’AAA’ size (UM-4) batteries.  
3. Put the Battery Compartment Cover back on and rotate the screws clockwise  
to secure it in place.  
This equipment has been tested and found to comply with the limits for a Radio  
Receiver, pursuant to Part 15 of the FCC Rules. These limits are designed to  
provide reasonable protection against harmful interference in a residential  
installation. This equipment generates, uses and can radiate radio frequency  
energy and, if not installed and used in accordance with the instructions, may  
cause harmful interference to radio communications.  
IMPORTANT: Be sure that the batteries are installed correctly. Wrong  
polarity may damage the unit.  
4. For better performance and longer operating time, we recommend only using  
alkaline-type batteries.  
5. (a) Do not mix old and new batteries.  
(b) Do not mix alkaline, standard (carbon-zinc) or rechargeable  
(nickel-cadmium) batteries.  
6. If the unit is not to be used for an extended period of time, remove the  
However, there is no guarantee that interference will not occur in a particular  
installation. If this equipment does cause harmful interference to radio or television  
reception, which can be determined by turning the equipment off and on, the user  
is encouraged to try to correct the interference by one or more of the following  
Download from All Manuals Search And Download.  

Expand Contents

Jensen Automobile Electronics AOM 7694 User Manual
Jensen Car Stereo System VM9414 User Manual
Jensen Digital Camera KT7009A User Manual
Jensen Home Theater System JHT525 User Manual
Jensen Jsbw 210 Manual