VM8012
Installation and Operation Manual
Watts Peak
Watts en Crête
Vatios el Máximo
40W x 4
160
Download from Www.Somanuals.com. All Manuals Search And Download.
VM8012
TABLE OF CONTENTS
Introduction ..............................................................................................1
Installation ................................................................................................1
Wiring .......................................................................................................3
Front Panel Release ................................................................................4
Remote Control ........................................................................................5
Operation .................................................................................................6
Tuner Operation .......................................................................................8
Disc/MP3/WMA Playback ........................................................................9
System Setup Menu ...............................................................................11
USB/SD Operation .................................................................................13
Care and Maintenance ...........................................................................16
Troubleshooting .....................................................................................17
Specifications .........................................................................................18
i
Download from Www.Somanuals.com. All Manuals Search And Download.
VM8012
ii
Download from Www.Somanuals.com. All Manuals Search And Download.
VM8012
2. Remove Transport Screws
INTRODUCTION
Congratulations on your purchase of the Jensen VM8012 Mobile
Multimedia Receiver. It’s a good idea to read all of the instructions before
beginning the installation. We recommend having your Jensen VM8012
installed by a reputable installation shop.
TRANSPORT SCREWS
INSTALLATION
HALF SLEEVE
This unit is designed for installation in cars, trucks and vans with an existing
radio opening. In many cases, a special installation kit will be required to
mount the radio to the dashboard. These kits are available at electronics
supply stores and car stereo specialty shops. Always check the kit
application before purchasing to make sure the kit works with your vehicle.
If you have trouble locating a kit or need installation assistance, contact
Technical Support at 1-800-323-4815 from 8:30am to 7:00pm EST Monday
through Friday and from 9:00am to 5:00pm EST on Saturday.
/
1
INT
2
RDM
RPT
LOC
3
4
SRC
MUTE
DISP
5
LOUD
6
ST/MO
AS
BAND
3. Remove Radio from Sleeve
Lift latches on both sides of sleeve to remove half-sleeve from radio.
Mounting Sleeve Installation
Tools and Supplies
1. Slide the mounting sleeve off the chassis. If it is locked into position,
use the removal tools (supplied) to disengage it.
2. Check the dashboard opening size by sliding the mounting sleeve into
it.
The following tools and supplies are needed to install the radio:
•
•
•
Torx type, flathead and Philips screwdrivers
Wire cutters and strippers
Tools to remove existing radio (screwdriver, socket wrench set or other
tools)
•
•
•
•
•
•
Electrical tape
Crimping tool
Volt meter/test light
Crimp connections
18 gauge wire for power connections
16-18 gauge speaker wire
If the opening is too small, carefully cut or file as necessary until the
sleeve easily slides into the opening. Do not force the sleeve into the
opening or cause it to bend or bow. Check for sufficient space behind
the dashboard for the radio chassis.
Preparation
1. Disconnect Battery
Before you begin, always disconnect the battery negative terminal.
3. Locate the series of bend tabs along the top, bottom, and sides of the
mounting sleeve. With the sleeve fully inserted into the dashboard
opening, bend as many of the tabs outward as necessary to firmly
secure the sleeve to the dashboard.
NOTE: If the VM8012 is to be installed in a car equipped with an on-
board drive or navigation computer, do not disconnect the battery
cable. If the cable is disconnected, the computer memory may be lost.
Under these conditions, use extra caution during installation to avoid
causing a short circuit.
CAUTION: For proper operation of the DVD player, the chassis must
be mounted within 20° of horizontal. Make sure the unit is mounted
within this limitation.
1
Download from Www.Somanuals.com. All Manuals Search And Download.
|