Jensen MP3 Docking Station JiSS 585 User Manual

Universal Docking Station with RF  
Wireless Speakers for iPod  
USER MANUAL  
JiSS-585  
(iPod® Not Included)  
PLEASE READ THIS USER MANUAL COMPLETELY BEFORE  
OPERATING THIS UNIT AND RETAIN THIS BOOKLET FOR  
FUTURE REFERENCE.  
Download from Www.Somanuals.com. All Manuals Search And Download.  

Expand Contents

WARNING  
Do not throw the product into fire to avoid danger of explosion.  
Do not immerse into water or get soaked since the battery charging function will be lost.  
Place the product far away from heat sources, and protect the product from direct  
sunlight.  
Do not use the product where electric appliances are prohibited.  
Protect the product from violent impact and vibrations.  
No compensation responsibility for malfunctions caused by improper use.  
Do not attempt to disassemble or alter any part of the unit that is not expressly described  
in this guide. Internal inspections, alternations and repairs should be conducted by  
qualified service personnel.  
IMPORTANT SAFETY INSTRUCTIONS  
When used in the directed manner, this unit has been designed and manufactured to ensure your  
personal safety. However, improper use can result in potential electrical shock or fire hazards. Please  
read all safety and operating instructions carefully before installation and use, and keep these  
instructions handy for future reference. Take special note of all warnings listed in these instructions and  
on the unit.  
1. Water and Moisture  
The unit should not be used near water. For example: near a bathtub, washbowl, kitchen sink,  
laundry tub, swimming pool or in a set basement.  
2. Ventilation  
This unit should be situated so that its location or position does not interfere with its proper  
ventilation. For example, it should not be situated on a bed, sofa, rug or similar surface that may  
block the ventilation openings. Also, it should not be placed in a built-in installation, such as a  
bookcase or cabinet, which may impede the flow of air through the ventilation openings.  
3. Heat  
The unit should be situated away from heat sources such as radiators, heat registers, stoves or other  
appliances (including amplifiers) that produce heat.  
4. Power Source  
The unit should be connected to a power supply only of the type described in the operating  
instructions or as marked on the appliance.  
5. Power Cord Protection  
Power supply cords should be routed so that they are not likely to be walked on or pinched by items  
placed upon or against them. It is always best to have a clear area from where the cord exits the unit  
to where it is plugged into a DC outlet.  
Download from Www.Somanuals.com. All Manuals Search And Download.  
2
6. Cleaning  
The unit should be cleaned properly with care.  
7. Objects and Liquid Entry  
Care should be taken so that objects do not fall and liquids are not spilled into any opening or vents  
located on the product.  
8. Attachments  
Do not use attachment not recommended by the product manufacturer.  
9. Lightning and Power Surge Protection  
Unplug the unit from the wall outlet and disconnect the periods of time. This will prevent damage to  
the product due to lightning and power-line surges.  
10. Overloading  
Do not overload wall outlets, extension cords, or integral convenience receptacles as this can result  
in a risk of fire of electrical shock.  
11. Damage Requiring Service  
This unit should be serviced by qualified service personnel when:  
A. The power supply cord or plug has been damaged.  
B. Objects have fallen into or fluid has been spilled into the enclosure.  
C. The unit has been exposed to rain.  
D. The unit has been dropped or the enclosure damaged.  
E. The unit exhibits a marked change in performance or does not operate normally.  
12. Periods of Nonuse  
If the unit is to be left unused for an extended period of time, such as a month or longer, the power  
cord should be unplugged from the unit to prevent damage or corrosion.  
13. Servicing  
The user should not attempt to service the unit beyond those methods described in the user’s  
operating instructions. Service methods not covered in the operating instruction should be referred  
to qualified service personnel.  
COMPLIANCE WITH FCC REGULATIONS  
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two  
conditions:  
(1) this device may not cause harmful interference, and  
(2) this device must accept any interference received, including interference that may  
cause undesired operation.  
NOTE: This equipment has been tested and found to comply with the limits for a Class B  
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide  
reasonable protection against harmful interference in a residential installation. This equipment  
generates, uses and can radiate radio frequency energy and, if not installed and used in  
accordance with the instructions, may cause harmful interference to radio communications.  
However, there is no guarantee that interference will not occur in a particular installation. If this  
Download from Www.Somanuals.com. All Manuals Search And Download.  
3
equipment does cause harmful interference to radio or television reception, which can be  
determined by turning the equipment off and on, the user is encouraged to try to correct the  
interference by one or more of the following measures:  
-
-
-
Reorient or relocate the receiving antenna.  
Increase the separation between the equipment and receiver.  
Connect the equipment into an outlet on a circuit different from that to which the receiver is  
connected.  
-
Consult the dealer or an experienced radio/TV technician for help.  
CAUTION:  
Changes or modifications not expressly approved by the party  
responsible for compliance could void the user’s authority to operate the equipment.  
POWER SOURCES  
1. Power of Main Base  
The main base is operated by AC power.  
AC adaptor  
Input: 120V ~ 60Hz  
Output: 9V  
1500mA  
Power installation: Insert the AC adaptor plug into DC Jack at the rear side of base.  
2. Power of Individual Speaker  
Each speaker has 1 built-in rechargeable lithium battery for independent playback. Before the  
first use, we recommend to charge each speaker for 4 hours. When speaker is placed on the  
powered base(Power ON/OFF switch turns to blue), charging will start automatically. The  
charging LED indicator is in red color during charging, and will turn green afterwards.  
3. Power of Remote Control  
To use the remote control, please ensure the remote control battery CR2025 (included) is  
installed properly. Replace the remote control battery when it stops working. It is highly  
recommended to use a good quality button cell.  
Note: Room lighting and battery life can affect the operating range of remote control.  
Download from Www.Somanuals.com. All Manuals Search And Download.  
4
ACCESSORIES  
Please see below items are included in the package:  
1. AC Adaptor  
2. AUX in Cord (3.5mm)  
3. Remote Control (include button cell CR2025)  
4. User Manuals (English and Spanish)  
5. Warranty Card  
LOCATION OF CONTROL  
1. Base (Top View)  
2. Base (Rear View)  
Download from Www.Somanuals.com. All Manuals Search And Download.  
5
3. Speaker Unit  
4. Remote Control  
GENERAL OPERATION  
1. Select a proper docking adaptor (enclosed when  
purchase an iPod) and place it into the  
base, then dock your iPod gently.  
Download from Www.Somanuals.com. All Manuals Search And Download.  
6
2. Plug the AC adaptor plug into DC power Jack at  
the rear side of base.  
3. Press the power button on the base or remote control to turn the unit on. Switch on the  
speakers to play your iPod. Choose the best channel through the “Channel” button at the  
rear of the base until the speakers receive the right signal.  
4. Press ‘Vol+” or ‘Vol-‘ to choose a proper volume level, then you should now be able to take  
the speakers freely from room to room without disruption (Subject to its surroundings,  
approximately 100 feet in the open area without any interference).  
5. If using iPod shuffle or other audio source with 3.5 mm headphone output jack, connect it  
to the AUX line in jack on the rear of base. (AUX in will not work when an iPod is docked)  
6. Press the power button on the base or remote control to turn off the unit.  
TROUBLESHOOTING GUIDE  
Should you experience difficulties in the use of this player, please refer to the following chart or  
call 1-800-777-5331 for Customer Service.  
Symptom  
Possible problem  
Solution  
The base does not  
AC adaptor is not plugged into a Plug the AC adaptor into a wall outlet  
switch on (no power) wall outlet or the connector is not and plug the connector into the DC  
plugged into the DC jack on the  
back of the unit.  
jack on the unit.  
Wall outlet is not functioning.  
Plug another device into the same  
outlet to confirm the outlet is working.  
Make sure the dock cradle is the  
proper fit for your iPod.  
Using no/wrong iPod cradle.  
iPod is not installed properly.  
iPod does not  
respond to the  
speaker system  
Remove your iPod from the dock and  
check for any obstruction on the  
connectors in the docking and on  
your iPod. Then reseat it in the dock.  
Please make sure that your iPod is  
Your iPod is locked up.  
Download from Www.Somanuals.com. All Manuals Search And Download.  
7